Revision Setup

Frank Johansson Updated by Frank Johansson

 Navigate to Axdata® > Engineering > Setup > Change Notification Parameters . Under General you can define if you want to date control active revisions of the BOM. If you want to have more than one active revision you must select “No” in the parameter for “General setting” under “Setup”. If you select “Yes”, you may only have one active revision of the Item BOM. This limitation is not valid for “Approved” revisions.

Under the parameter settings for Approval levels, you may define the steps and statuses for the approval of the new revision.

Setting of Number sequence is done upon installation and normally not changed. If you need to change the Number sequence, select “View details” and change the number.

Under the parameter settings for “Notification operations”, you may a set off necessary operations to take before approval of ECO with new revision.

How did we do?

Released Item Setup

Change notification parameters

Contact